Xerox VersaLink B405DN User Manual page 171

6. Specify the consecutive number of sample pages to print.
a. Touch Print Settings.
b. To increase or decrease the number of sample pages, for Quantity, touch Plus (+) or Minus (-),
then touch OK.
To print the sample pages, touch Print Sample.
7.
8. When printing is completed, touch Close.
9. On the sample pages, for Side 1, use a ruler to measure the distance of the printed image from the
top, bottom, left, and right edges.
Note: For identification, a single dot is printed on Side 1, and two dots are printed on Side 2.
10. For Side 2, measure the distance of the printed image from the top, bottom, left, and right edges.
11. If the image is centered, no adjustment is required. If not centered, adjust the paper registration.
For details, refer to Performing a Paper Registration Adjustment.
Performing a Paper Registration Adjustment
At the printer control panel, press the Home button.
1.
2. Log in as administrator. For details, refer to the System Administrator Guide at
www.xerox.com/office/VLB405docs.
3. Touch Device > Support > Image Position.
4. To adjust registration, select the source paper tray.
Touch Paper Supply.
a.
b. Touch the desired tray.
5. Using the chart printed in Verifying Paper Registration, select the side for registration.
a. For adjusting Side 1, touch Adjusted Side, then touch Side 1.
b. For adjusting Side 2, touch Adjusted Side, then touch Side 2.
Xerox VersaLink B405 Multifunction Printer
® ®
Maintenance
171
User Guide