Table of Contents
Advertisement
36
Operation
WDR/BLC setting
Use WDR/BLC option to set the options for BLC or WDR
camera.
1. Select [WDR/BLC] option on the [EXPOSURE] menu.
2. Use [Near] or [Far] button to select a mode then press
[Open] or [Close].
•
WDR LEVEL: WDR (Wide dynamic range) feature
can be very helpful to cope with very challenging
lighting conditions. It is capable of capturing both
of the dark part and bright part and combining
the differences into a scene to generate a highly
realistic image as original scene. Set the WDR level
(LOW, MIDDLE, HIGH).
•
BLC LEVEL: Camera's backlight compensation
feature helps alleviate issues of visibility in high
contrast areas. Set the BLC level (LOW, MIDDLE,
HIGH).
•
HSBLC: Use for masking brightness of the specific
area to view the subject more clearly.
4
-
HSBLC LEVEL: Select the HSBLC level. (LOW,
MIDDLE, HIGH).
-
COLOR: Use [Near] or [Far] button to select a
color.
•
OFF: Not used.
BRIGHTNESS setting
You can increase the brightness of the darkened video.
If you set the brightness to lower value, the image is
darkened. If you set the brightness to higher value, the
image gets bright.
1. Select [BRIGHTNESS] option on the [EXPOSURE] menu.
2. Use [Near] or [Far] button to set the bright level.
LT913-B.CNLDLLI_MFL66281601_ENG.indd 36
SHUTTER (Shutter Speed) setting
Select the desired shutter speed for camera exposure. You
can change the shutter speed to higher speed to capture
fast-moving subjects, though the image becomes darker.
1. Select [SHUTTER] option on the [EXPOSURE] menu.
2. Use [Near] or [Far] button to set shutter speed.
SENS-UP setting
If pictures are not clear due to darkness, use this function
to increase the sensitivity of picture.
1. Select [SENS-UP] option on the [EXPOSURE] menu.
2. Use [Near] or [Far] button to set the SENS-UP limit. To
set the SENS-UP function, select the [AUTO] on the
[SHUTTER].
NOTE
If you set to one of the SHUTTER options except AUTO
on the [SHUTTER] menu, the [SENS-UP] setting is not
available and [---] mark is displayed.
White Balance setting
Select the method by which the camera shifts its output
colors to compensate for the color of a light source.
1. Select [WHITE BALANCE] option on the [CAMERA SET]
menu.
2. Use [Near] or [Far] button to select a mode then press
[Open] or [Close].
•
ATW (Auto-Tracing White Balance): In this mode,
the color temperature range for the proper white
balance is approximately from 1 800 K to 10 500 K.
Proper white balance may not be obtained under
the following conditions:
-
When the color temperature is out of the
1 800 K to 10 500 K range.
-
When the scene mostly contains high color
8/6/10 4:00 PM
Advertisement
Table of Contents
