Table of Contents
Advertisement
14
Installation
PORT A of the LT913/713NI/PI series
Description
RS-485 +
RS-485 -
NC
ALARM IN COM
ALARM IN 1
ALARM IN 2
ALARM IN 3
3
ALARM IN 4
PORT A of the LT913/713N/P series
Description
RS-485 +
RS-485 -
NC
ALARM IN COM
ALARM IN 1
ALARM IN 2
ALARM IN 3
ALARM IN 4
LT913-B.CNLDLLI_MFL66281601_ENG.indd 14
Alarm Input function
This speed dome camera has a terminal that can sense the
Color
alarm signals.
If the alarm sensor that has installed in a door, window,
Red/White
safe etc. sense a touch or shock, the alarm sensor send the
Black/White
alarm signal to the camera and the camera will observe the
sensed position.
Change the observe position to a sensor that senses a
Red
touch or shock then return to the position that previously
observed. (Set the Duration Time of Alarm Input function
White
to "3 to 255".)
Function status
Light Green
While observe a
Yellow
specific position.
Pink
While operating
Preset Tour
function.
Color
While operating
Green
Auto Pan function.
Blue
While operating
Yellow
Pattern function.
Pink
Gray
in case of HOME
POSITION is ON.
White
Violet
During the dwell time for alarm, you can not control the
controller.
Mode
Change the observe position to the
alarmed position then return to the
position that previously observed.
Stop preset touring and change the
observe position to the alarmed
position then restart the preset
touring again.
Stop auto panning and change the
observe position to the alarmed
position then restart the auto
panning again.
Stop operating pattern function
and change the observe position
to the alarmed position during the
dwell time then restart the pattern
function again.
After Alarm has been cleared and
finished the dwell time, it moves to
the HOME POSITION and spend the
dwell time at that position.
NOTE
8/6/10 3:59 PM
Advertisement
Table of Contents
