Table of Contents
Advertisement
remove the dome cover and wipe all moist surfaces
with a soft cloth.
•
Before operating, please check proper temperature,
humidity and power source ratings.
Use the camera under conditions where temperature
is from -10 °C to 50 °C and humidity is below 80 %. The
input power source is AC 24 V.
•
Consumables
Parts having contacts such as the lens-drive motors,
cooling fan built inside the camera are subject to wear
with time. About replacement and maintenance of
such parts, please ask the nearest service center.
Camera Installation Location
Discuss the installation location for the camera with your
retailer, and select a place that is strong enough
for the installation.
•
Install the camera on a ceiling (concrete, etc.) at a
location that is sufficiently strong to support it.
•
Install the camera body on the foundation section
of the building or sections having sufficient bearing
strength.
Never install or use the camera in the following
locations
•
Do not install it in areas exposed to direct sunlight or
rain.
•
Do not install the camera near the air outlet of an air
conditioner.
•
Near a swimming pool or other areas where chemicals
are used.
•
Food preparation areas and other locations where there
are large amounts of steam vapor and oil, in flammable
atmospheres, other special environments.
•
Areas where radiation, X-rays, strong electric waves, or
magnetism is generated.
•
At sea, in coastal areas, or in areas where corrosive gas
is being generated.
•
Areas outside of the allowable ambient operating
temperature range.
LT913-B.CNLDLLI_MFL66281601_ENG.indd 5
About Static Electricity Removal
Before installing the camera, touch a metal case or other
metallic parts with your hand to remove static electricity
from your body.
Do not install in areas subjected to high amounts of
humidity or dust.
Doing so may cause internal components to damage more
easily or malfunction.
Do not wire cables near power lines.
Tightening the Screws
Screws should be tightened sufficiently in accordance with
the materials and structure of the installation location. After
tightening the screws, visually inspect them to make sure
there is no unevenness and that each screw is tight.
Safety Information
5
1
8/6/10 3:59 PM
Advertisement
Table of Contents
