Table of Contents
Advertisement
Technical specification
Specification
system)
8x universal programming module (8x 48-pin DIL ZIF sockets and 8x ISP connector)
operation result LEDs, LED power
line power input 100-240VAC/60W max.
banana jack for ESD wrist straps connection
banana jack for connection to ground
Specification (PC system inside of programmer)
Microsoft Windows XP Embedded operation system
PC Intel Core 2 Quad 2.66 GHz
2 GB RAM
320 GB HDD
SPECIFICATION (valid for each programming module)
HARDWARE
Base unit, DACs
USB 2.0 high-speed compatible port, up to 480 Mbit/s transfer rate
on-board intelligence: powerful microprocessor and FPGA based state machine
three D/A converters for VCCP, VPP1, and VPP2, controllable rise and fall time
VCCP range 0..8V/1A
VPP1, VPP2 range 0..26V/1A
autocalibration/selftest
selftest capability
Socket, pindriver
48-pin DIL ZIF (Zero Insertion Force) socket accepts both 300/600 mil devices up to
48-pin
pindrivers: 48 universal
VCCP / VPP1 / VPP2 can be connected to each pin
perfect ground for each pin
FPGA based TTL driver provides H, L, CLK, pull-up, pull-down on all pindriver pins
analog pindriver output level selectable from 1.8 V up to 26V
current limitation, overcurrent shutdown, power failure shutdown
ESD protection on each pin of socket (IEC1000-4-2: 15kV air, 8kV contact)
continuity test: each pin is tested before every programming operation
ISP connector
20-pin male type with miss insertion lock
6 TTL pindrivers, provides H, L, CLK, pull-up, pull-down; level H selectable from 1.8V
up to 5V to handle all (low-voltage) devices.
1x VCCP voltage (range 2V..7V/100mA) , can be applied to two pins
programmed chip voltage (VCCP) with both source/sink capability and voltage sense
1x VPP voltage (range 2V..25V/50mA)
(DATAMAN-848PRO2
multiprogramming
11
Advertisement
Table of Contents
