If You Have An Unsupported Target Device - Dataman -848PRO2 User Manual

Hardware warnings
Because DATAMAN-848PRO2 have internal power supply, follow these special
Circuit breakers (overcurrent protection) must be a part of building electrical
installation.
Power cord is a main disconnecting element for disconnecting programmer from
mains. Pull out power cord plug from outlet to disconnect programmer from mains.
If you connect programmer to mains by 2 wire cable, or 3 wire power cord is inserted
to 2 pin mains plug, for proper prevention before electrical injury you must connect
ground wire to black "banana jack for connection to ground" (marked with ground
symbol ) on the back site of programmer.

If you have an unsupported target device

If you need to operate on a target device not supported by the control program for
programmer, please do not despair and follow these next steps:
Look in the device list of the latest version of the control program on our Internet site
(section Download, file corresponded to your programmer). Your new target device
may already be included in this version! If yes, download and install the new version of
the control program.
Contact DATAMAN directly by completing and submitting the "TECHNICAL
SUPPORT REQUEST" available from our website www.dataman.com. We may need
to request data sheets and samples of your target device. Any samples will be
returned to you after we include your target device in a new version of PG4UW.
Device described in this manual is class A products. In domestic
environment this product may cause radio interference in which case
the user may be required to take adequate measures.
precautions:
Class A ITE notice
47