Dataman -848PRO2 User Manual page 34

Menu Options
Options / Switch to Operator Mode... Switch to Administrator Mode
Program PG4UWMC is set by default to Administrator Mode. It means, no operation
blocking for user is applied. But in production, there is suitable to block some menu
commands, to ensure, user does not modify important program settings or
configuration. Operator Mode is used for this purpose.
PG4UWMC has Operator Mode very similar to Protected mode of program PG4UW.
The difference is, that Operator Mode can be activated by menu command but cannot
be activated by Project file. Another difference is that Operator Mode settings of
PG4UWMC are saved to configuration .ini file of PG4UWMC while program PG4UWMC
is closed. During next start of application PG4UWMC the recent Operator Mode settings
obtained from .ini file are used. If you wish to see more information about Protected
mode of single application PG4UW, please look at Options / Protected mode.
There is menu command - Options / Switch to Operator Mode... that allow using
Operator Mode in PG4UWMC. After selecting the menu, Switch to Operator Mode
dialog appears. User has to enter password twice to confirm the password is correct.
After successful password confirmation program switches to Operator Mode.
Keep "Load project" operation allowed is set to inactive state by default - it means
the Load project operation button and menu will be disabled when Operator Mode is
active. If the option is enabled (checked), the Load project operation button and menu
will be allowed in Operator Mode.
Command "Load project" in Operator Mode can also be disabled automatically, by
loading of protected project file that has set Protected mode option not to allow another
34