Table of Contents
Advertisement
Because work with remote desktop is similar to working on local station, please
continue to read chapter "Local administration".
Local administration
For local administration of Stand-Alone programmer you must have connected
standard PS/2 keyboard, PS/2 mouse, and standard analog display with resolution
1024x768 and 32bit color supported.
Operating disk is divided to three volumes. First volume named as "Recovery" (C:)
contains software for OS recovery of programmer to state as shipped from factory.
Standard start time of programmer is about 2 minutes. When device doesn't start in 10
minutes, then it may be necessary to perform OS recovery. Before operating system
recovery, connect monitor to programmer, and kindly report what you see to
programmer manufacturer. For next steps refer to "Operating system recovery"
chapter. Second volume is "System" (D:), and contains Windows XP Embedded
operating system.
Warning: Do not delete, change files or perform any writes on "Recovery" or "System"
disk volumes.
Third volume is named as "Data" (E:). This volume contains Programmer, Projects,
Logs, Updates and Temp directories.
Programmer is directory, where main control software is installed. In directory Logs are
saved log files from operations with devices. When OS update files are available, they
should be saved to Updates directory. Your project files should be in Projects
directory. Exact update steps will be distributed with operating system updates.
For programmer reliability operating system is configured with write filters on
"Recovery" and "System" disk. As a side effect of these filters, any configuration
changes in entire operating system will be wasted after restart or shutdown
programmer.
How to make changes in system permanent
If you want persistently save changes on your BeeHive208S follow these steps:
1.
run "fbwfmgr.exe /disable" (needed admin rights if you are login as operator, for
example with "runas" command from operator account, or login as admin).
2.
perform restart DATAMAN-848PRO2 system.
3.
make desired changes in your DATAMAN-848PRO2 system.
4.
run "fbwfmgr.exe /enable", and restart DATAMAN-848PRO2 immediate. Now
should be changes permanent (until system recovery will be performed).
Operating system recovery
Recovery OS performs refreshing of programmer operating system to state as it was
shipped from factory.
Before operating system recovery, connect monitor to programmer, and kindly report
what you see to programmer manufacturer.
To perform operating system recovery you must have connected keyboard, mouse and
display. Turn on programmer. After starting BIOS you will see this screen:
44
Advertisement
Table of Contents
