Lenovo ThinkSystem SN550 V2 Reference page 91

User Action:
Information only; no action is required.
• FQXSPPP4050I: Management Controller [arg1] reset was initiated to activate PFR Firmware.
Management Controller reset was initiated to activate PFR Firmware.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID: 22
CIM Prefix: IMM CIM ID: 0253
User Action:
Information only; no action is required.
• FQXSPPR2001I: [ManagedElementName] detected as absent.
This message is for the use case when an implementation has detected a Managed Element is Absent.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID:
CIM Prefix: PLAT CIM ID: 0392
User Action:
Information only; no action is required
• FQXSPPU0001N: An Over-Temperature Condition has been detected on [ProcessorElementName].
This message is for the use case when an implementation has detected an Over-Temperature Condition
Detected for Processor.
Severity: Error
Serviceable: Yes
Automatically notify Support: No
Alert Category: Critical - Temperature
SNMP Trap ID: 0
CIM Prefix: PLAT CIM ID: 0036
User Action:
Complete the following steps until the problem is solved:
1. Check the event log of XClarity Controller (XCC) for any fan- or cooling-related issues.
2. Make sure that the airflow at the front and rear of the chassis is not obstructed and that fillers are in
place, clean, and correctly installed.
3. Make sure that the room temperature is within the range of operating specifications.
4. Make sure that the processor 1 heat sink is securely installed.
5. Make sure that the processor 1 heat sink is installed correctly and the thermal interface is correctly
applied.
6. (Trained technician only) Replace the system board.
• FQXSPPU0002G: The Processor [ProcessorElementName] is operating in a Degraded State.
.
Chapter 2 XClarity Controller events
87