Lenovo ThinkSystem SN550 V2 Reference page 53

SNMP Trap ID: 50
CIM Prefix: PLAT CIM ID: 0244
User Action:
Complete the following steps:
1. Check Lenovo support site for an applicable service bulletin or firmware update for the system or
adapter that applies to this error.
2. If the problem persists, collect Service Data log.
3. Contact Lenovo Support.
• FQXSPIO0014J: Bus [SensorElementName] is operating in a degraded state.
This message is for the use case when an implementation has detected a Bus is Degraded.
Severity: Warning
Serviceable: Yes
Automatically notify Support: No
Alert Category: Warning - Other
SNMP Trap ID: 60
CIM Prefix: PLAT CIM ID: 0246
User Action:
Complete the following steps:
1. Reseat the adapter or install the adapter to another slot.
2. If the problem still exists then replace the adapter.
3. If the problem still exists then contact Lenovo service.
• FQXSPIO0015M: Fault in slot [PhysicalConnectorSystemElementName] on system
[ComputerSystemElementName].
This message is for the use case when an implementation has detected a Fault in a slot.
Severity: Error
Serviceable: Yes
Automatically notify Support: Yes
Alert Category: Critical - Other
SNMP Trap ID: 50
CIM Prefix: PLAT CIM ID: 0330
User Action:
Complete the following steps to fix the error:
1. Make sure that all I/O expansion adapters have correct and matching levels of device drivers and
firmware.
2. Check the event log of XClarity Controller for additional information about failing components. Check
http://support.lenovo.com/ for TECH tips or firmware updates that might correct the error.
3. If there are no entries related to the error in the event log, contact Lenovo support.
• FQXSPIO2001I: The connector [PhysicalConnectorElementName] configuration error has been
repaired.
This message is for the use case when an implementation has detected an Interconnect Configuration
was Repaired.
Severity: Info
Serviceable: No
.
Chapter 2 XClarity Controller events
49