Scanning The Next Original During Copying - Toshiba ES9465 MFP Copying Manual

2 HOW TO MAKE COPIES

Scanning the next original during copying

Even if copying is in progress or "READY (WARMING UP)" is displayed on the touch panel, you can scan the next original
(auto job start).
1
Place the original(s).
2
Set the number of copy sets and the copy modes as required.
The new job starts in the copy modes that you previously selected unless you select other modes.
3
Press the [START] button on the control panel.
A maximum of 1000 sheets can be scanned per 1 copy job or up
until the embedded memory becomes full. When the hard disk is
not installed, the maximum of sheets that can be scanned per 1
copy job is approx. 180 (when the color mode is "FULL COLOR" or
"AUTO COLOR") or approx. 250 (when the color mode is
"BLACK"), or up until the embedded memory becomes full.
Confirming auto jobs
You can confirm which jobs are in waiting on the touch panel or cancel them as required. For details, see the following
page:
P.184 "Confirming Copy Job Status"
Canceling jobs being scanned
Press the [STOP] button on the control panel to stop a job while originals are
being scanned.
When you press [JOB CANCEL] on the touch panel or the [RESET] button
on the control panel while the scanning is being paused, the scanning will
end. (In this case, the data which were scanned before the job was paused
will be copied.) To restart the scanning, press the [START] button.
36 Making Copies