Table of Contents
Advertisement
2.HOW TO MAKE COPIES
Continuous feed mode
The feeding mode is set at "continuous feed mode" by default. Once you set the originals and then press the [START]
button, they are scanned page by page continuously. It is useful when you want to copy more than one original at one
time.
1
Align all the originals.
Collate the originals in the order that you want them to be copied. The top sheet of the originals will be copied first.
2
Place the originals with their face up and align the
side guides to the original length.
Regardless of their sizes, originals are acceptable up to 100
sheets (35 to 80 g/m
For mixed-size originals, see the following page:
P.60 "Copying mixed-size originals in one operation"
For long originals
The original stopper prevents the scanned originals from falling off. Pull
it out from the RADF and raise the sub-stopper.
Lower the sub-stopper and slightly lift the original stopper to push it
back in after you have finished using it.
When there are too many originals to be scanned at one time, divide the originals into several sets before copying.
Place the first set of the originals and then press [CONTINUE] on the touch panel while the data of this set are being
scanned. When this scanning is finished, place the next set of the originals and press the [START] button on the
control panel. (If you press [CONTINUE], this button may not work shortly before scanning is finished.)
2
(9.3 to 20 lb.)) or 16 mm (0.62") in height.
2 HOW TO MAKE COPIES
2
1
Placing Originals
31
Advertisement
Table of Contents
