Table of Contents
Advertisement
1.BEFORE USING EQUIPMENT
6
While holding the green lever of the side guide in the
direction of the arrow, set the side guide to the paper
size.
Adjust the side guides with both hands.
7
Check that there is no gap between the paper and the
side guides, as well as the paper and the end guide.
If the gap is too wide, it could cause paper misfeeding, or the paper
size could not be correctly detected.
Between the paper and side guides ("A" in the figure):
Make sure there is no gap. (0.5 mm (0.02") or less on one side, 1.0 mm
(0.04") or less in total) However, if paper misfeeding occurs, make a
gap.
Between the paper and end guide ("B" in the figure):
Make sure there is no gap. (0.5 mm (0.02") or less)
8
Change the paper size indicator if required.
9
Push the tray straight into this equipment carefully until it comes to a stop.
Be careful not to let your fingers be caught when pushing the tray into this equipment.
This could injure you.
1 BEFORE USING EQUIPMENT
A
B
Placing Paper
15
Advertisement
Table of Contents
