Supero 2027TR-H70QRF User Manual page 60

SUPERSERVER 2027TR-H70RF/H70FRF/H70QRF USER'S MANUAL
Watch Dog Enable/Disable
Watch Dog (JWD1) is a system monitor
that can reboot the system when a
software application hangs. Close Pins
1-2 to reset the system if an application
hangs. Close Pins 2-3 to generate
non-maskable interrupt signals for the
application that hangs. See the table on
the right for jumper settings. Watch Dog
must also be enabled in the BIOS.
VGA Enable
Jumper JPG1 allows the user to enable
the onboard VGA connectors. The
default setting is 1-2 to enable the
connection. See the table on the right
for jumper settings.
BMC Enable
Jumper JPB1 allows you to enable the
onboard BMC (Baseboard Management)
Controller to provide IPMI 2.O/KVM
support on the motherboard. See the
table on the right for jumper settings.
Infi niBand (IB) Enable
B o t h t h e X 9 D R T - H I B Q F
X9DRT-HIBFF serverboards have
Jumper JIB1, which allows you to enable
the onboard Infi niBand connector. The
default setting is 1-2 to enable the
connection. See the table on the right
for jumper settings.
Watch Dog (JWD1)
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
Open
VGA Enable (JPG1)
Jumper Settings
Jumper Setting
1-2
2-3
BMC Enable (JPB1)
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
Infi niBand Enable (JIB1)
Jumper Settings
a n d
Jumper Setting
1-2
2-3
5-22
Defi nition
Reset (default)
NMI
Disabled
Defi nition
Enabled (Default)
Disabled
Defi nition
BMC Enable (Default)
Normal
Defi nition
Enabled (Default)
Disabled