Advantech TREK-723 User Manual page 6

Risc all-in-one mobile data terminal
Hide thumbs Also See for TREK-723:
Table of Contents

Advertisement

Ordering Information
Part Number
TREK-722R-A0E
TREK-722R-CBCEA0E TREK-722R-A0E w/ GPS, CDMA, BT, CE
TREK-722R-GBCEA0E TREK-722R-A0E w/ GPS, GPRS, BT, CE
TREK-722R-HBCEA0E TREK-722R-A0E w/ GPS, HSPA, BT, CE
TREK-723R-A0E
TREK-723R-CBCEA0E TREK-723R-A0E w/ GPS, CDMA, BT, CE
TREK-723R-GBCEA0E TREK-723R-A0E w/ GPS, GPRS, BT, CE
TREK-723R-HBCEA0E TREK-723R-A0E w/ GPS, HSPA, BT, CE
Safety Instructions
1.
Read these safety instructions carefully.
2.
Keep this User Manual for later reference.
3.
Disconnect this equipment from any AC outlet before cleaning. Use a damp
cloth. Do not use liquid or spray detergents for cleaning.
4.
For plug-in equipment, the power outlet socket must be located near the equip-
ment and must be easily accessible.
5.
Keep this equipment away from humidity.
6.
Put this equipment on a reliable surface during installation. Dropping it or letting
it fall may cause damage.
7.
Do not leave this equipment in an environment unconditioned where the storage
temperature under -30° C (-22° F) or above 70° C (158° F), it may damage the
equipment.
8.
Do not operate this equipment in an environment temperature may over 70° C
(158° F). The surface temperature of metal chassis may be scorch and hot.
9.
Make sure the voltage of the power source is correct before connecting the
equipment to the power outlet.
10.
Position the power cord so that people cannot step on it. Do not place anything
over the power cord.The voltage and current rating of the cord should be greater
than the voltage and current rating marked on the product.
11.
All cautions and warnings on the equipment should be noted.
12.
If the equipment is not used for a long time, disconnect it from the power source
to avoid damage by transient overvoltage.
13.
Never open the equipment. For safety reasons, the equipment should be
opened only by qualified service personnel.
14.
If one of the following situations arises, get the equipment checked by service
personnel:
The power cord or plug is damaged.
Liquid has penetrated into the equipment.
The equipment has been exposed to moisture.
The equipment does not work well, or you cannot get it to work according to
the user's manual.
The equipment has been dropped and damaged.
The equipment has obvious signs of breakage.
TREK-722/723 User Manual
Description
TREK-722 barebone
TREK-723 barebone
vi

Advertisement

Table of Contents
loading

This manual is also suitable for:

Trek-722Trek-72x-hb

Table of Contents