Flywheel - Husqvarna 522HS75X Workshop Manual

7.6 Flywheel

7.6.1 To disassemble the flywheel
1. Clean around the spark plug.
2. Remove the spark plug cap and the spark plug.
3. Put a piston stop in the spark plug hole.
CAUTION: Make sure that the piston stop
does not go into the exhaust port. There is a
risk of engine damage.
4. Remove the starter unit.
911 - 001 - 15.02.2019
5. Remove the nut that holds the flywheel.
6. Attach the flywheel removal tool to the crankshaft,
Servicing tools on page 11 . Keep a distance
refer to
of approximately 2 mm between the flywheel
removal tool and the flywheel.
7. Hit the flywheel removal tool lightly with a hammer
while you lift the flywheel with your other hand.
Repair instructions - 19