Table of Contents
Advertisement
6. Put an assembly sleeve on the crankshaft on the
clutch side to prevent damage to the sealing ring.
Lubricate the crankshaft with oil and install the
sealing ring.
7. Assemble in the opposite sequence of
the crankcase and crankshaft on page 43 .
46 - Repair instructions
7.14 Fuel tank
7.14.1 To do a tank venting
1. Drain the fuel tank and put the product with the top
down.
2. Remove the transparent fuel hose from the
carburetor and connect it to the pressure tester.
3. Tighten the fuel tank cap. Make sure that there are
no leaks around the bushings in the fuel tank.
4. Use the pressure tester to make a negative pressure
To assemble
in the tank. If there is no pressure or the negative
pressure is very low, replace the fuel tank.
911 - 001 - 15.02.2019
Advertisement
Table of Contents
