Table of Contents
Advertisement
8. Remove the locking washers (A) with a screwdriver.
This causes deformation of the 2 washers. Discard
the 2 washers.
C
B
A
9. Remove the starter pawls (C) and the recoil springs
(B).
7.6.2 To clean and examine the flywheel
•
Examine the flywheel for cracks and damages.
20 - Repair instructions
7.6.3 To assemble the flywheel
1. Make sure that the key in the flywheel and keyway in
the crankshaft are not damaged.
2. Attach the recoil springs (B) and the starter pawls
(C) on the flywheel.
Note: Make sure that the recoil spring is attached to
the flywheel, as the illustration shows.
3. Attach new locking washers (A).
CAUTION: Always use new locking
washers.
C
B
A
911 - 001 - 15.02.2019
Advertisement
Table of Contents
