Table of Contents
Advertisement
7.6 Flywheel
7.6.1 To disassemble the flywheel
1. Clean around the spark plug.
2. Remove the spark plug cap and the spark plug.
3. Put a piston stop in the spark plug hole.
CAUTION: Make sure that the piston stop
does not go into the exhaust port. There is a
risk of engine damage.
4. Remove the starter unit.
20 - Repair instructions
5. Remove the nut that holds the flywheel.
6. Attach the flywheel removal tool to the crankshaft,
Servicing tools on page 12 . Keep a distance
refer to
of approximately 2 mm between the flywheel
removal tool and the flywheel. Hit the flywheel
removal tool lightly with a hammer while you lift the
flywheel with your other hand.
1017 - 002 - 25.11.2020
Advertisement
Table of Contents
