Husqvarna 522HS75X Workshop Manual page 25

3. Examine the distance between the flywheel magnet
and the ignition module with an air gap gauge. Refer
Servicing data on page 6 for the correct distance.
to
4. Adjust the distance, if it is necessary. Loosen the
screws and adjust the ignition module until the
distance is correct. Tighten the screws to the correct
Servicing data on page 6 .
torque. Refer to
5. Install the muffler cover and the starter unit.
6. Do a spark test. If there is no spark, the ignition
module is damaged and must be replaced.
911 - 001 - 15.02.2019
7.7.7 To remove the ignition module
1. Remove the starter unit.
2. Remove the spark plug cap and the spark plug.
3. Remove the muffler cover.
4. Remove the cable (A) from the ignition module.
A
Repair instructions - 25