Table of Contents
Advertisement
5. Put a new cylinder base gasket on the crankcase.
CAUTION: Make sure that the cylinder base
gasket does not have signs of damage and
wear.
6. Install the support plate from the piston assembly kit.
40 - Repair instructions
7. Use the clamp from the piston assembly kit to
compress the piston ring. Carefully push the piston
into the cylinder opening. Tighten the 2 screws to
the specified torque. Refer to
6 .
8. Install the remaining parts in the opposite sequence
to how they were removed.
7.13 Crankshaft and crankcase
7.13.1 To get access to the crankcase and
crankshaft
To remove the cylinder and piston
1. Do step 1-13 in
on page 35 .
2. Remove the ignition module, if it is attached.
Servicing data on page
911 - 001 - 15.02.2019
Advertisement
Table of Contents
