ZyXEL Communications EX3510-B0 User Manual page 83

Figure 47 Network Setting > Broadband > Add/Edit New WAN Interface (Bridge Mode)
The following table describes the fields in this screen.
Table 17 Network Setting > Broadband > Add/Edit New WAN Interface (Bridge Mode)
LABEL DESCRIPTION
General Click this switch to enable or disable the interface. When the switch goes to the right
function is enabled. Otherwise, it is not.
Name Enter a service name of the connection.
Type This field shows an Ethernet connection.
Mode Select Bridge when your ISP provides you more than one IP address and you want the connected
computers to get individual IP address from ISP's DHCP server directly. If you select Bridge, you
cannot use routing functions, such as QoS, Firewall, DHCP server and NAT on traffic from the
selected LAN port(s).
VLAN Click this switch to enable or disable VLAN on this WAN interface. When the switch goes to the right
, the function is enabled. Otherwise, it is not.
802.1p IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into a MAC-layer frame that
contains bits to define class of service.
Select the IEEE 802.1p priority level (from 0 to 7) to add to traffic through this connection. The greater
the number, the higher the priority level.
802.1q Type the VLAN ID number (from 0 to 4094) for traffic through this connection.
WAN MAC Address (You can set the WAN MAC address in the following section.)
Factory Select Factory Default to use the factory assigned default MAC address.
Default
Clone LAN Select this option to clone the MAC address of the computer (displaying in the screen) from which
Host's MAC you are configuring the Zyxel Device. It is advisable to clone the MAC address from a computer on
Address your LAN even if your ISP does not presently require MAC address authentication.
IP Enter the IP address of the computer on the LAN whose MAC address you are cloning.
Address
Chapter 6 Broadband
EX3510-B0 User's Guide
83
, the