Dmx Configuration; Dmx Mode; Dmx Addressing - ProLights EVO160F User Manual

3.7 DMX CONFIGURATION

EVO160F is equipped with different DMX configuration.
• Press the button MENU so many times until shows [SET], and press the button ENTER to confirm.
• Press the button UP/DOWN to select [PERS], and press the button ENTER to confirm.
• Select the desired DMX configuration [UNO- DOS - STD.P] through the buttons UP and DOWN.
The tables on page 13 indicate the operating mode and DMX value. The EVO160F is equipped with
3/5-poles XLR connections.

3.8 DMX MODE

• Press the button MENU so many times until the display shows [RUN], and press the button ENTER to
confirm.
• Select in submenu [DMX], press ENTER button to confirm the choice.
• From main menu, press the button MENU so many times until the display shows [ADDR], and press the
button ENTER to confirm.
• Press UP/DOWN button to select the desired value (001-512).
• After the setting value is automatically saved.

3.9 DMX ADDRESSING

To able to operate the EVO160F with a light controller, adjust the DMX start address for the first a DMX
channel. If e. g. address 33 on the controller is provided for controlling the function of the first DMX
channel, adjust the start address 33 on the EVO160F. The other functions of the light effect panel are then
automatically assigned to the following addresses.
An example with the start address 33 is shown below:
Number of
Start address
DMX channels
(example)
5 33
DMX Address: 33
DMX512 Controller
EVO160F
DMX Address Next possible start
occupied address for unit No. 1
33-37
DMX Address: 38
Example 5 DMX channels configuration (STD.P mode)
Next possible start
address for unit No. 2
38
DMX Address: 43
Next possible start
address for unit No. 3
43
DMX Address: 48
Fig.4
11
48
. . . . . . . . . . . .