Table of Contents
Advertisement
Available languages
Available languages
10
3.7 LINKING
Several units may be interconnected in order to control all further slave units to the same effect of the
master unit.
1. Connect the DMX OUT of the master unit via 3/5-poles XLR cable to the DMX IN of the first slave unit.
2. Connect the DMX OUT of the first slave unit to the DMX IN of the second slave unit, etc. until all units
are connected in a chain.
3.8 DMX CONFIGURATION
EVO392FL is equipped with different DMX configuration.
• Press the button MENU so many times until shows [SET], and press the button ENTER to confirm.
• Press the button UP/DOWN to select [PERS], and press the button ENTER to confirm.
• Select the desired DMX configuration [UNO, STD.W] through the buttons UP and DOWN.
The tables on page 12 indicate the operating mode and DMX value. The EVO392FL is equipped with
3/5-poles XLR connections.
3.9 DMX ADDRESSING
• Press the button MENU so many times until the display shows [DMX], and press the button ENTER to
confirm.
• Press UP/DOWN button to select the desired value (001-512).
• After the setting value is automatically saved.
To able to operate the EVO392FL with a light controller, adjust the DMX start address for the first a DMX
channel. If e. g. address 33 on the controller is provided for controlling the function of the first DMX
channel, adjust the start address 33 on the EVO392FL. The other functions of the light effect panel are
then automatically assigned to the following addresses.
An example with the start address 33 is shown below:
Number of
Start address
DMX channels
(example)
2
33
DMX Address: 33
DMX512 Controller
EVO 392FL
DMX Address
Next possible start
occupied
address for unit No. 1
33-34
DMX Address: 36
Esempio di configurazione a 2 canali DMX (modalità STD.W)
Next possible start
address for unit No. 2
35
DMX Address: 39
Next possible start
address for unit No. 3
37
DMX Address: 42
Fig.5
39
. . . . . . . . . . . .
Advertisement
Chapters
Table of Contents
