Dmx Addressing; Dmx Configuration; Linking - ProLights ECLFR2KTW User Manual

10

3.4 DMX ADDRESSING

To set DMX addressing follow the instructions below:
• Press the button MENU to enter the menu mode.
• Press UP/DOWN button to select Connect. Press the ENTER button to confirm.
• Press UP/DOWN button to select DMX Address. Press the ENTER button to confirm.
• Press UP/DOWN button to select the desired value 001-512. Press the ENTER button to confirm.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
To able to operate the ECLFR2KTW with a light controller, adjust the DMX start address for the first a
DMX channel. If e. g. address 33 on the controller is provided for controlling the function of the first DMX
channel, adjust the start address 33 on the ECLFR2KTW. The other functions of the light effect panel are
then automatically assigned to the following addresses.

3.5 DMX CONFIGURATION

The ECLFR2KTW has different DMX channels configurations available selectable through the control panel.
• Press the button MENU to enter the menu mode.
• Press UP/DOWN button to select Connect. Press the ENTER button to confirm.
• Press UP/DOWN button to select DMX mode. Then press the ENTER button to confirm.
• Press UP/DOWN button to select the desired configuration (1CH, 2CH 2, 5CH1, 5CH2, 7CH1, 7CH2, 8CH , 12CH ,
13CH, 16CH, 19CH, 21CH); then press the ENTER button to save.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
The tables on page 14, 15, 16, 17, 18, 19, 20 indicate the operating mode and DMX value. The ECLFR2KTW
is equipped with 5-pole XLR connections.

3.6 LINKING

Several units may be interconnected; follow the instructions below:
1. Connect the DMX OUT of the master unit via 5-pole XLR cable to the DMX IN of the first slave unit.
2. Connect the DMX OUT of the first slave unit to the DMX IN of the second slave unit, etc. until all units
are connected in a chain.
Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For longer cable runs we suggest a terminator at the last fixture (see page 21).
DMX Address: 33
DMX512 Controller
ECLFR2KTW
DMX Address: 38 DMX Address: 43
Fig.5 - Example 5 DMX channels configuration
DMX Address: 48
. . . . . . . . . . . .
. . . . . . . . . . . .