Using Instructions - Heinner MG1600TA-UV Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 13
www.heinner.com
12. Switch the appliance off before detaching and install any accessory.
13. Wait until moving parts have stopped running before you remove the parts of the
appliance.
14. Never immerse the motor unit in the water or any other liquid, nor rinse it under
the tap. Use only a moist cloth to clean the motor unit.
15. Do not attempt to grind bones, nuts or other hard items.
16. Never reach into the cutter housing. Always use the pusher.
17. This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been give supervision or instruction concerning use of the
appliance by a person responsible for their safety.
18. Children should be supervised to ensure that they do not play with the appliance.
19. If the appliance is locked, please press Reversal button (REV). The meat locked in
cutter housing is untrodden, so the appliance can renew its usual condition.
VI. USING INSTRUCTIONS
Press the fasten button,hold the head and insert it into the inlet when inserting
1.
please pay attention the head must be slanted as per arrow indicated on the top, see
(fig.1), then move the head anticlockwise so that the head being fastened tightly.
(fig.2)
2.
Place the snake into the head, long end first, and turn to feed the screw slightly until
it is set into the motor housing. (fig.3)
Place the cutting blade onto the snake shaft with the blade facing the front as
3.
illustrated (fig.4).If it is not fitted properly, meat will not be grinded.
Place the desired cutting plate next to the cutting blade, fitting protrusions in the
4.
slot. (fig.5)
5.
Support or press the center of the cutting plate with one finger then screw the fixing
ring tight with another hand (fig.6). Do not over tighten.
6.
Place the hopper plate on the head and fix it into position.
Locate the unit on a firm place.
7.
The air passage at the bottom and the side of the motor housing should be kept free
8.
and not blocked.
1600W, 50/60Hz, 220-240V
15

Advertisement

Table of Contents
loading

Table of Contents