Using Instructions; For The First Time - Heinner MG-Y1800X Instruction Manual

www.heinner.com
V.

USING INSTRUCTIONS

FOR THE FIRST TIME

• Check that voltage indicated on the rating label corresponds to the mains
voltage in your home.
• Wash all parts (except body) in warm soapy water.
• Before plugging in, ensure the "ON/OFF/ Reverse" switch is turned to "OFF"
position.
INSTRUCTION FOR USE
ASSEMBLING
• Holding the head and insert it in the inlet with one hand, place the locking
knob into the hole on the side of the motor housing, tighten it clockwise to
secure the head (fig.2).
• Place the feed screw into the head, long end first, by turning the feed screw
slightly until it is set into the motor housing (fig.3).
• Place the cutting blade onto the feed screw shaft with the blade facing the
front as illustrated (fig.4). If it is not fitted properly, meat will not be ground.
• Place the desired cutting plate next to the cutting blade, fitting protrusions in
the slots (fig.5).
• Support or press the centre of the cutting plate with one finger then screw the
fixing ring until tight with another hand (fig.6). Do not over tighten.
• Place the hopper plate on the head and fix into position.
• Locate the unit on a firm place.
• The air passage at the bottom and the side of the motor housing should be
kept free and not blocked.
1800W, 50-60Hz, 220-240V
15