Page 1
MODEL: CASCADE-6TC With Power Switch INSTALLATION, OPERATION AND SERVICING INSTRUCTIONS Please read these instructions carefully before operating your boiler for the first time Calomax Limited Lupton Avenue, Leeds LS9 7DD Tel. 0113 249 6681 Fax. 0113 235 0358 E-mail: service@calomax.co.uk...
CONTENTS INTRODUCTION INTRODUCTION PAGE 3 Thank you for purchasing a Calomax Cascade-6TC boiler. All our CHECK LIST products are designed to give years of simple, reliable operation. To ensure this, it is important that the installation and subsequent APPROVALS servicing is carried out by a suitably qualified engineer in CONSTRUCTION accordance with these instructions.
MODEL WEIGHT WEIGHT lid and rear panel. Calomax ltd recommend a clearance of 50mm on all side of the boiler. A suitably qualified engineer must install Cascade- 16.5 KG 56.5 KG...
ELECTRICAL CONNECTIONS Cascade-6TC boilers require fixed wiring to the rear terminal block. Note: A means of disconnection must be provided in which at least 3mm When the green service indicator light on the front of the boiler is separation between the live and neutral poles of the supply exists.
SPARE PARTS GENERAL OPERATION (Refer to centre pages for location). Hold a cup below the tap or place large vessels on the drip • tray. Care must be taken to avoid injury through splashing or over-filling. To begin filling, pull the handle forward or push it backward •...
4x pulse. For further assistance, contact our service department on 0113 249 6681 e-mail service@calomax. co.uk. or find a local service engineer at www.calomax.co.uk Once the rear panel is removed, access to the Service Area has been gained. This access must be restricted to persons having knowledge and practical experience of the appliance, in particular as far as safety and hygiene are concerned.
Page 7
Exploded parts view If parts required are not identified, please contact (To be read in conjunction with the spare parts list) Calomax Limited (Wrapper not shown for clarity) * Includes nuts, washers, etc. Page 12 Page 13...
Page 8
Failure to remove this The temperature potentiometer (Pot) is pre-set at Calomax and scale and/or moisture could cause the sensor to indicate to will only require adjustment in exceptional circumstances. Contact the PCB that water is covering the elements, whether or not Calomax for advice.
Page 9
BODY LID GASKET ASSEMBLY KIT SPRSK CASLPK NBPRG WATER INLET LEVEL PROBES KIT PRESSURE RELIEF SINGLE POLE For more information visit our website at www.calomax.co.uk or call 0113 249 6681 HOSE GROMMET ON/OFF SWITCH Page 16 Page 17 NB: Not to scale.
Page 10
RED 1.5mm (2068) The Cascade 6TC boiler has an in built thermal cutout device to protect the element in a boil dry situation. Should the cutout be activated, contact an approved Calomax service provider for advice. Page 18 Page 19...
Page 11
WARRANTY GUARANTEE (UK Mainland customers only) SERVICE HISTORY AND NOTES Calomax have manufactured water boilers in the UK for over 50 years. We are proud of our products and the back-up service we provide Properly maintained and serviced, a Calomax boiler should last many years and we have no hesitation in providing a full 12 months (mainland U.K.) parts and labour warranty for all models.
Page 12
SERVICE HISTORY AND NOTES SERVICE HISTORY AND NOTES Page 22 Page 23...
Page 13
50 - 60 Hz Power rating 6kW (max) single phase Note: All measurements are approximate. PLEASE CONTACT OUR SERVICE DEPARTMENT FOR ASSISTANCE Calomax Limited, Lupton Avenue, Leeds LS9 7DD Tel: 0113 249 6681 Fax: 0113 235 0358 e-mail: service@calomax.co.uk Page 24...
Need help?
Do you have a question about the CASCADE-6TC and is the answer not in the manual?
Questions and answers