Wac6103D-I - ZyXEL Communications WAC6000 Series Manual

Table 6 WAC6500 Series LEDs (continued)
LED
Management
WLAN
WLAN
UPLINK
LAN
Locator

1.6.2 WAC6103D-I

The LEDs will stay ON when the WAC6103D-I is ready. You can change this setting in the
Maintenance > LEDs > Suppression screen.
Chapter 1 Introduction
COLOR STATUS
Green On
Slow Blinking (blink
for 3 times, Off for 3s)
Off
Green On
Blinking
Off
Green On
Blinking
Off
Amber/ On
Green
Blinking
Off
Amber/ On
Green
Blinking
Off
White Blinking
Off
NWA5000 / WAC6000 Series User's Guide
DESCRIPTION
The WAC AP is managed by a controller.
The WAC AP is searching (discovery) for a controller.
The WAC AP is in standalone mode.
The 2.4 GHz WLAN is active.
The 2.4 GHz WLAN is transmitting or receiving data.
The 2.4 GHz WLAN is not active.
The 5 GHz WLAN is active.
The 5 GHz WLAN is transmitting or receiving data.
The 5 GHz WLAN is not active.
Amber - The port is operating as a 100-Mbps
connection.
Green - The port is operating as a Gigabit connection
(1000 Mbps).
The WAC is sending/receiving data through the port.
The port is not connected.
Amber - The port is operating as a 100-Mbps
connection.
Green - The port is operating as a Gigabit connection
(1000 Mbps).
The LAN port is sending/receiving data through the
port.
The LAN port is not connected.
The Locator is activated and will show the actual
location of the WAC between several devices in the
network.
The Locator function is off.
22