Network Status - ZyXEL Communications WAC6000 Series Manual

4.3 Network Status

Use this screen to look at general Ethernet interface information and packet statistics. To access
this screen, click Monitor > Network Status.
Figure 21 Monitor > Network Status
The following table describes the labels in this screen.
Table 22 Monitor > Network Status
LABEL
Interface
Summary
IPv6 Interface
Summary
IP Addr/Netmask
IP Address
IP Assignment
Action
Port Statistics
Table
Poll Interval
Set Interval
Stop
Name
Chapter 4 Monitor
DESCRIPTION
Use the Interface Summary section for IPv4 network settings. Use the IPv6 Interface
Summary section for IPv6 network settings if you connect your NWA/WAC to an IPv6
network. Both sections have similar fields as described below.
This field displays the current IP address (and subnet mask) of the interface. If the IP
address is 0.0.0.0 (in the IPv4 network) or :: (in the IPv6 network), the interface does not
have an IP address yet.
This field displays how the interface gets its IPv4 address.
Static - This interface has a static IPv4 address.
DHCP Client - This interface gets its IPv4 address from a DHCP server.
Use this field to get or to update the IP address for the interface. Click Renew to send a
new DHCP request to a DHCP server. If the interface cannot use one of these ways to get
or to update its IP address, this field displays n/a.
Enter how often you want this window to be updated automatically, and click Set Interval.
Click this to set the Poll Interval the screen uses.
Click this to stop the window from updating automatically. You can start it again by setting
the Poll Interval and clicking Set Interval.
This field displays the name of the interface.
NWA5000 / WAC6000 Series User's Guide
48