ZyXEL Communications WAC6000 Series Manual page 44

Table 19 Dashboard (continued)
LABEL DESCRIPTION
Boot Status This field displays details about the NWA/WAC's startup state.
OK - The NWA/WAC started up successfully.
Firmware update OK - A firmware update was successful.
Problematic configuration after firmware update - The application of the
configuration failed after a firmware upgrade.
System default configuration - The NWA/WAC successfully applied the system
default configuration. This occurs when the NWA/WAC starts for the first time or you
intentionally reset the NWA/WAC to the system default settings.
Fallback to lastgood configuration - The NWA/WAC was unable to apply the startup-
config.conf configuration file and fell back to the lastgood.conf configuration file.
Fallback to system default configuration - The NWA/WAC was unable to apply the
lastgood.conf configuration file and fell back to the system default configuration file
(system-default.conf).
Booting in progress - The NWA/WAC is still applying the system configuration.
Management This shows whether the NWA/WAC is set to work as a stand alone AP.
Mode
Power Mode This displays the NWA/WAC's power status.
Full - the NWA/WAC reveives power using a power adaptor and/or through a PoE
switch/injector using IEEE 802.3at PoE plus.
Limited - the NWA/WAC reveives power through a PoE switch/injector using IEEE
802.3af PoE even when it is also connected to a power source using a power adaptor.
When the NWA/WAC is in limited power mode, the NWA/WAC throughput decreases
and has just one transmitting radio chain.
It always shows Full if the NWA/WAC does not support power detection. At the time of
writing, only the WAC6500 series APs support the power detection feature.
Interface Status If an Ethernet interface does not have any physical ports associated with it, its entry is
Summary displayed in light gray text. Click the Detail icon to go to a (more detailed) summary
screen of interface statistics.
Name This field displays the name of each interface.
Status This field displays the current status of each interface. The possible values depend on
what type of interface it is.
Inactive - The Ethernet interface is disabled.
Down - The Ethernet interface is enabled but not connected.
Speed / Duplex - The Ethernet interface is enabled and connected. This field displays
the port speed and duplex setting (Full or Half).
VID This field displays the VLAN ID to which the interface belongs.
IP Addr/ This field displays the current IP address and subnet mask assigned to the interface. If
Netmask
the IP address is 0.0.0.0, the interface is disabled or did not receive an IP address and
subnet mask via DHCP.
If this interface is a member of an active virtual router, this field displays the IP address
it is currently using. This is either the static IP address of the interface (if it is the
master) or the management IP address (if it is a backup).
IP Assignment This field displays how the interface gets its IP address.
Static - This interface has a static IP address.
DHCP Client - This interface gets its IP address from a DHCP server.
Chapter 3 Dashboard
NWA5000 / WAC6000 Series User's Guide
44