Table of Contents
Advertisement
Installation Guide
Power Monitoring
E31E Series
Split-Core Current
Sensors
Installation
Z206855-0B
Page 7 of 26
Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Aerospond, Veris, and the Veris 'V' logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.
1.888.610.7664
50 A Split-Core CT
Voltage Rating 300 VAC
Accuracy
±1%
Temperature
0° to 60°C
Agency
UL 61010-1 Recognized, EN61010-1 UL 61010-1 Recognized, EN61010-1 UL 61010-1 Recognized, EN61010-1
Observe precautions for handling static sensitive
devices to avoid damage to the circuitry that
is not covered under the factory warranty.
Disconnect power to the panel before beginning the installation.
1. Locate a surface inside the electrical enclosure to mount the E31E. Decide whether to mount the E31E vertically or horizontally.
The E31E is shipped with the brackets placed for vertical mounting. If mounting horizontally, loosen the screws on the sides of
the E31E that hold the brackets in place (do not fully remove the screws from the E31E housing). Loosen the screws on the other
two sides of the housing (do not fully remove the screws from the E31E housing), and set the brackets into their new positions.
Tighten all screws.
Vertical Mounting
Horizontal Mounting
2. Install the E31E in the panel (hardware not provided). A grounding connection is located on the housing (see below). Use this
stud to ground the device when it is mounted on a nonconductive surface.
Panel 2
Panel 1
©2014 Veris Industries USA 800.354.8556 or +1.503.598.4564 / support@veris.com
Other companies' trademarks are hereby acknowledged to belong to their respective owners.
www.calcert.com
15
10
20
5
25
0
30
100 A Split-Core CT
300 VAC (CE), 600 VAC (UL)
300 VAC (CE), 600 VAC (UL)
±0.5%
±1%
0° to 60°C
0° to 60°C
E31E
Ground
sales@calcert.com
TM
200 A Split-Core CT
04142
Advertisement
Table of Contents
