Table of Contents
Advertisement
Installation Guide
Power Monitoring
E31E Series
Gateway
Configuration (cont.)
Z206855-0B
Page 20 of 26
Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Aerospond, Veris, and the Veris 'V' logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.
1.888.610.7664
The next field for the BACnet MS/TP protocol mode is the MSTP_Max_Master, which allows this value to be set prior to using
BACnet software to access the E31E. The default value of 127 works regardless of the addresses the MS/TP network uses, but
selecting a lower value may optimize the network. Do not set this value lower than the highest address on the network. To set this
value via BACnet, write to the Max_Master property of the device object for the E31E's virtual router.
The final field is the MSTP_MAC_Addr, which sets the MAC address for the virtual router. The E31E panel(s) are devices on the
internal BACnet network and are not directly addressable as MAC addresses on the MS/TP network.
2. BACnet IP mode
BACnet IP mode uses the same DeviceID_Offset and Virt_Router_Net parameters described above for BACnet MS/TP mode. One
additional parameter, BACnet_IP_Port, is used to set the UDP port. Most BACnet systems use the default port (47808 decimal,
0xBAC0 hex) that is recommended in the BACnet standard as the only UDP port. Some large systems need to segment the
enterprise and use more than port. If so, enter the number of the port you need to use to access this device. BACnet IP mode does
not use MSTP_Max_Master or MSTP_MAC_Addr.
BACnet IP mode adds another field called BBMD_Enable. See the section BBMD Support for a full description of how to enable and
use BBMD support.
©2014 Veris Industries USA 800.354.8556 or +1.503.598.4564 / support@veris.com
Other companies' trademarks are hereby acknowledged to belong to their respective owners.
www.calcert.com
15
10
20
5
25
0
30
sales@calcert.com
TM
04142
Advertisement
Table of Contents
