Control Panel - Supermicro AS-1024US-TRT User Manual

UltraO Riser Card LAN LED Header
JF2 is a header for the UltraO Riser Card LAN LED header.
SATA Ports
The H12DSU-iN has eighteen SATA 3.0 ports (SATA0-17) that are supported by the chipset.
NVMe Connections
Four NVM Express (NVMe) ports are located on the motherboard (two for each processor).
These ports provide high-speed, low-latency PCIexp. 3.0 x4 connections directly from the CPU
to NVMe Solid State (SSD) drives. This greatly increases SSD data-throughput performance
and significantly reduces PCIe latency by simplifying driver/software requirements resulted
from direct PCIe interface from the CPU to the NVMe SSD drives.

Control Panel

JF1 contains header pins for various control panel connections designed specifically for use
with Supermicro chassis. See the figure below for the pin locations and definitions of the
control panel buttons and LED indicators.
All JF1 wires have been bundled into a single cable to simplify this connection. Make sure
the red wire plugs into pin 1 as marked on the motherboard. The other end connects to the
control panel PCB board.
Power On LED (Control signal)
20 19
(Ground)
Key
HDD LED (Activity signal)
NIC1 LED (Ground)
NIC2 LED (Ground)
OH/Fan Fail LED (Ground)
Power Fail LED (Ground)
(Ground)
(Ground)
2 1
Figure 4-1. JF1: Control Panel Pins
53
Chapter 4: Motherboard Connections
NMI (Control signal)
Key
(5V standby)
(Vcc)
(Vcc)
(Vcc)
(Vcc)
(Vcc)
Reset Button (Data signal)
Power Button (Data signal)