Table of Contents
Advertisement
24
en | Configuration
6
Configuration
Notice!
Take care not to drop the end caps to prevent damage to the cap threads.
Making Adjustments to the Camera Lens
You must remove the front end cap to make lens adjustments. You may need to remove the
inner bracket assembly for easier access to the lens controls.
Camera adjustments may be done remotely via the Bilinx "through the coax" interface or
directly on the camera itself by removing the inner bracket assembly. When the Bilinx
communications link is active, the buttons on the cameras are disabled. Refer to Operation,
page 29 for more information.
Note: You may need to remove the sunshield to remove the front end cap more easily.
1. Loosen the set screw on the front end cap using the supplied hex key.
2. Loosen the front end cap using the supplied multi-use tool. To prevent damage to the o-
ring, for every half turn counterclockwise turn back one quarter turn clockwise.
3. Unscrew the front end cap by hand.
4. To adjust the lens and to access the DINION menu buttons:
–
Using the supplied multi-use tool, loosen the three (3) bolts (Item 1, below) that hold the
inner mounting bracket assembly.
–
Pull the assembly out of the housing.
2016.03 | 1.0 | F.01U.318.222
Installation Manual
Available from A1 Security Cameras
www.a1securitycameras.com email: sales@a1securitycameras.com
EX65 Explosion-Protected Camera
Bosch Security Systems, Inc.
Advertisement
Table of Contents
