ProLights DIAMOND19WH User Manual page 27

choice. Press the LEFT button repeatedly to exit the menu and save changes.
Theater Mode
Select this function if you want less noise from the machine; the LED output will be limited to decrease
the heating and fan speed:
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll the menu, select the Set icon, then press the ENTER button to enter
the next menu.
• Press the UP/DOWN button to scroll through the menu, select Fixture Set, and press the ENTER button
to enter the next menu.
• Press the UP/DOWN button to scroll through the menu, and then select Theater Mode and press ENTER
to confirm. Press the UP/DOWN button to select Yes /No, press the ENTER button to confirm your choice.
• Press the LEFT button repeatedly to exit the menu and save changes.
Frequency
Select this function to change the frequency of the LEDs:
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll the menu, select the Set icon, then press the ENTER button to enter
the next menu.
• Press the UP/DOWN button to scroll through the menu, select Fixture Set, and press the ENTER button
to enter the next menu.
• Press the UP/DOWN button to scroll through the menu, and then select the desired frequency
(600/1200/2000/2400/4000 Hz/25 kHz) and press ENTER to confirm.
• Press the LEFT button repeatedly to exit the menu and save changes.
Hibernation
Select this function to activate the standby mode. This function will be activated automatically after a
period of inactivity, which is defined by the user. In standby mode, the lamp and all engines will not be
fed if no signal is sent. The unit will automatically reset and will return to operation as soon as the DMX
signal is sent.
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll through the menu, select the Set icon, then press the ENTER button
to enter the next menu.
• Press the UP/DOWN button to scroll through the menu, select UI Set, and press the ENTER button to
enter the next menu.
• Press the UP/DOWN to scroll through the menu, select Hibernation and press ENTER to confirm.
• Select the desired time through the arrow keys or select Not Hibernation to disable this function, then
press the ENTER button to confirm your choice.
• Press the LEFT button repeatedly to exit the menu and save changes.
Fixture ID and RDM
With this function you can call up various submenus via RDM.
This device is RDM ready. RDM stands for "Remote Device Management" and makes remote control of
devices connected to the DMX-bus possible. Manual settings like adjusting the DMX starting address are
no longer needed. This is especially useful when the device is installed in a remote area. RDM is integrated
in DMX without influencing the connections. The RDM-data is transmitted via the standard XLR-poles 1
and 2 – new DMX-cables are not necessary. RDM ready and conventional DMX devices can be operated
in one DMX line. The RDM protocol sends own packages in the DMX512 data feed and does not influence
conventional devices. If DMX splitters are used and RDM control is to be used, these splitters must sup-
port RDM. The number and type of RDM parameters depend on the RDM controller (not included) is used.
DIAMOND19
25