Camera Network Configurations; Assemble & Install Camera; Understand How Your Laptop / Computer Connect To Internet - Avtech AVN806 Series Network Setup Manual

Ir network camera

Hide thumbs Also See for AVN806 Series:

Table of Contents

1. CAMERA NETWORK CONFIGURATIONS

Please follow the instructions below to finish camera installation and network configurations.

You may configure the network connection of this network camera with your laptop / computer, or with your iPhone®

or iPad® based on your network environment.

1.1 Assemble & Install Camera

Step1: Fasten the base of the bracket (the round one) to where the camera is installed.

Step2: Assemble the bracket and the camera, and adjust the viewing angle of the camera.

Note: The tilt angle of the camera is limited to 30 degrees, and the right/left pan angle is limited to 15

degrees each.

Step3: Connect the supplied power adapter to the camera's power jack (DC 5V / 2A) on the rear panel and the power

outlet.

Step4: Continue to proceed network configurations as instructed in the following sections.

Then, connect your network camera directly to your wireless router / router / hub / modem with a network cable,

and power it on.

Note: Check

(LAN) status indicator is always on, not blinking. If it's blinking, check your RJ45

network cable and ensure it's not disconnected or defect.

Table of Contents

Do you have a question about the AVN806 Series and is the answer not in the manual?