Camera Network Configurations; Assemble & Install Camera; Understand How Your Laptop / Computer Connect To Internet - Avtech AVM302A Network Setup Manual

1. CAMERA NETWORK CONFIGURATIONS

Please follow the instructions below to finish camera installation and network configurations.
You may configure the network connection of this network camera with your laptop / computer, or with your iPhone®
or iPad® based on your network environment.
1.1 Assemble & Install Camera
Step1: Fasten the base of the bracket (the round one) to where the camera is installed.
Step2: Assemble the bracket and the camera, and adjust the viewing angle of the camera.
Note: The tilt angle of the camera is limited to 30 degrees, and the right/left pan angle is limited to 15
degrees each.
Step3: Connect the optional power adapter to the camera's power jack (DC 5V / 2A) on the rear panel and the power
outlet.
Note: This camera also supports POE connection. For connection details, please refer to "APPENDIX 3
POE CONNECTION (Megapixel Camera Models Only)" at page 21.
Step4: Continue to proceed network configurations as instructed in the following sections.

1.2 Understand How Your Laptop / Computer Connect to Internet

Then, connect your network camera directly to your wireless router / router / hub / modem with a network cable,
and power it on.
5