Table of Contents
Advertisement
M0076814-03
Use a bar or a turning tool to turn over the engine
slowly. This procedure puts the oil on the cylinder
walls. Install all fuel injectors and tighten to the
correct torque. Refer to Disassembly and
Assembly Manual for more information.
10. Spray a thin amount of a mixture of 50 percent
VCI oil and 50 percent engine oil onto the following
components: flywheel, ring gear teeth, and starter
pinion. Install the covers to prevent evaporation of
the vapors from the VCI oil.
11. Apply a heavy amount of Multipurpose Grease to
all outside parts that move, such as rod threads,
ball joints, linkage.
Note: Install all covers. Ensure that tape has been
installed over all openings, air inlets, exhaust
openings, the flywheel housing, the crankcase
breathers, the dipstick tubes.
Ensure that all covers are airtight and
weatherproof. Use a waterproof weather resistant
tape such as Kendall No. 231 or an equivalent. Do
not use duct tape. Duct tape will only seal for a
short time.
12. Under most conditions, removing the batteries is
the best procedure. As an alternative, place the
batteries in storage. As needed, periodically
charge the batteries whilst the batteries are in
storage.
If the batteries are not removed, wash the tops of
the batteries until the tops are clean. Apply an
electrical charge to the batteries to obtain a
specific gravity of 1.225.
Disconnect the battery terminals. Place a plastic
cover over the batteries.
13. Remove the drive belts from the engine
14. Place a waterproof cover over the engine. Ensure
that the engine cover is secure. The cover should
be loose enough to allow air to circulate around
the engine to prevent damage from condensation.
15. Attach a tag with the storage date to the engine.
16. Remove the waterproof cover at 2 month or 3-
month intervals to check the engine for corrosion.
If the engine has signs of corrosion, repeat the
protection procedure.
Coolant System
Completely fill the cooling system before storage.
Engine Storage Procedure - Check
Refer to this Operation and Maintenance Manual,
"Fluid Recommendations" for more information about
coolants.
Aftertreatment
The engine must be allowed to perform a Diesel
Exhaust Fluid (DEF) purge before the battery
disconnect switch is turned off. Some applications,
the engine can be equipped with delayed engine
shutdown. Allow 2 minutes after the engine has
stopped before disconnecting the battery disconnect
switch.
The exhaust outlet of the aftertreatment must be
capped. To prevent damage to the exhaust outlet
connection during storage, the weight of the CEM
must not act on the exhaust outlet.
1. Ensure normal engine shutdown, allow the DEF to
be purged. Do not disconnect the battery
disconnect switch, allow 2 minutes after key off
before disconnection.
2. Fill the tank with DEF that meets all the
requirement defined in ISO 22241-1.
3. Ensure that all DEF lines and electrical connection
are connected prior to prevent crystal from
forming.
4. Ensure that the DEF filler cap is correctly installed.
Removing Application from
Storage
Follow the OEM recommendation for application
removal from storage.
Remove Engine from Storage
1. Remove all outside protective covers.
2. Change the oil and filters.
3. Check the condition of the fan and alternator belts.
Replace the belts, if necessary. Refer to this
Operation and Maintenance Manual, "Belts -
Inspect/Adjust/Replace" for the correct procedure.
4. Replace the fuel filter elements.
5. Remove the plastic covers from the air cleaner
elements.
6. Use a bar or a turning tool to turn the engine in the
normal direction of rotation. The procedure
ensures that no hydraulic locks or resistance exist.
7. Before starting the engine, remove the valve cover
or covers. Put a large amount of engine oil on the
camshaft, cam followers, and valve mechanism to
prevent damage to the mechanism.
101
Maintenance Section
Advertisement
Table of Contents
