Table of Contents
Advertisement
8.2.10
Data Program
MMC/SD CARD
PRINT MODE
REACTION ON-LINE
FAULT ON-LINE
CONTROL CHARS
DECIMAL
8.2.11
Information
CONTACT INFORMATION
SOFTWARE
VERSION
DATE
IDENTIFICATION
ENGINEERING
YES
YES
NO
POINT
02.01.00
May 5 2011
B5C 2.01 247
▪ This menu allows the user to program the output device
communication port configuration profiles for MMC/SD flash
card.
▪ PRINT MODE specifies the format in which the data will be sent
over the communication port to all output devices. The available
modes are STANDARD (includes time, date and calibrated
analysis data etc.), and ENGINEERING (includes un-calibrated
data, temperature and atmospheric pressure, pump diagnostic
information, liquid phase measurement information etc. in
addition to the STANDARD data).
▪ REACTION ON-LINE enables (YES by default) or disables (NO)
the automatic printout of the reaction result at the end of each
reaction.
▪ FAULT ON-LINE enables (YES by default) or disables (NO) the
automatic printout of a fault or warning log as soon as it occurs.
▪ CONTROL CHARS enables (YES) or disables (NO by default)
the control characters sent with the RS232 data for the output
device operation.
▪ DECIMAL specifies whether a POINT (.) by default or a COMMA
(,) character represents the decimal point in the downloaded
analysis data files for all output devices.
▪ Contact menu displays the contact details of the manufacturer
and if programmed the distributor.
▪ VERSION displays the system firmware (software) revision
number.
▪ DATE displays the firmware (software) revision date.
▪ IDENTICIFATION displays the specific identification number
(system serial number) for the BioTector.
Page 108
Advertisement
Table of Contents
