Checking Movable Parts; Every 50 Hours; Lubricating Grease Fittings; Checking Safety Devices - Kubota BX2350D Operator's Manual

58 PERIODIC SERVICE
BChecking Movable Parts
If any of the movable parts, such as levers and pedals, is
not smoothly moved because of rust or anything sticky, do
not attempt to force it into motion.
In the above case, remove the rust or the sticky thing, and
apply oil or grease on the relevant spot.
Otherwise, the machine may get damaged.

EVERY 50 HOURS

BLubricating Grease Fittings
Apply a small amount of multipurpose grease to the
following points every 50 hours:
If you operated the machine in extremely wet and muddy
conditions, lubricate grease fittings more often.
(1) Grease fitting (Speed control pedal)
(1) Battery terminals
BChecking Safety Devices
To avoid personal injury:
A Do not allow anyone near the tractor while
testing.
A If the tractor does not pass the test, do not
operate the tractor.
C Preparation before testing.
1. Sit on operator's seat.
2. Set the parking brake and stop the engine.
3. Shift the range gear shift lever to "NEUTRAL" position.
4. Check the speed control pedal "NEUTRAL" position.
5. Shift the PTO clutch lever to "OFF" position.
C Test 1: Switch for the speed control pedal
1. Make sure that the range gear shift lever is set in
"NEUTRAL" position.
2. Depress the speed control pedal.
3. Turn the key to "START" position.
4. The engine must not crank.
5. If it cranks, consult your local KUBOTA Dealer for this
service.
C Test 2: Switch for the PTO clutch lever
1. Make sure that the range gear shift lever is set in
"NEUTRAL" position.
2. Make sure that the speed control pedal is set in
"NEUTRAL" position.
3. Shift the PTO clutch lever to "ON" position.
4. Turn the key to "START" position.
5. The engine must not crank.
6. If it cranks, consult your local KUBOTA Dealer for this
service.
C Test 3: Switches for the operator's seat and the
speed control pedal
1. Make sure that the range gear shift lever is set in
"NEUTRAL" position.
2. Start the engine.
3. Depress the speed control pedal.
4. Stand up. (Do not get off the machine.)
5. The engine must shut off.
6. If it does not stop, consult your local KUBOTA Dealer
for this service.
C Test 4 : Switches for the operator's seat, PTO
clutch lever and PTO select lever at "Mid-PTO"
position or "Mid-Rear-PTO" position.
1. Start the engine.
2. Shift the PTO select lever to "Mid-PTO" position or
"Mid-Rear-PTO" position.
3. Engage the PTO clutch lever.
4. Stand up. (Do not get off the machine.)
5. The engine must shut off.
6. If it does not stop, consult your local KUBOTA Dealer
for this service.