Checking Coolant Level; Cleaning Panel And Radiator Screen - Kubota BX2350D Operator's Manual

56 PERIODIC SERVICE
BChecking Coolant Level
To avoid personal injury:
A Be sure to stop the engine and remove the key
before checking coolant level.
A Do not remove the radiator cap while coolant is
hot. When cool, slowly rotate cap to the first
stop and allow sufficient time for excess
pressure to escape before removing cap
completely.
1. Check to see that the coolant level is between the "H"
and "L" marks of recovery tank.
2. When the coolant level drops due to evaporation, add
soft water only. In case of leakage, add antifreeze and
soft water in the specified mixing ratio up to the "H"
level.
(See "Flushing Cooling System and Changing
Coolant" in "EVERY 2 YEARS" in "PERIODIC
SERVICE" section.)
(1) Recovery tank (A) "H"
(B) "L"
A If the radiator cap has to be removed, follow the
caution above and securely retighten the cap.
A Use clean, fresh soft water and anti-freeze to fill the
radiator.
A If water should leak, consult your local KUBOTA
Dealer.
BCleaning Panel and Radiator Screen
To avoid personal injury:
A Be sure to stop the engine and remove the key
before removing the screen.
A Before checking or cleaning it, wait long
enough until it cools down.
1. Detach the panel and clean it to be sure the holes are
not clogged with debris.
2. Detach the lower panel plate.
A If the dust or chaff is accumulated in the battery
compartment, clean it thoroughly.
(1) Panel
(2) Knob
(3) Center pillar
(1) Lower panel plate
(2) Wing bolts
(A) "DETACH"
(A) "DETACH"