Cleaning Air Cleaner Element - Kubota BX2350D Operator's Manual

C Direction for Storage
1. When storing the tractor for a long period, remove the
battery from tractor, adjust the electrolyte to the proper
level (refillable type only) and store in a dry place out
of direct sunlight.
2. The battery self-discharges while it is stored.
Recharge it once every three months in hot seasons
and once every six months in cold seasons.
(For non-accessible maintenance-free type batteries.)
Maintenance-free, non-accessible batteries are designed
to eliminate the need to add water. Yet the volume of
electrolyte above plates may eventually become depleted
due to abnormal conditions such as high heat or improper
regulator setting. Use a voltmeter to check the state of
charge. (See reference chart below to determine if
charging is necessary.)
Battery voltage
12.6
12.4
12.2
12.0
11.8
Reference state of charge
100% (Full charge)
75%
50%
25%
0%
PERIODIC SERVICE
BCleaning Air Cleaner Element
To avoid personal injury:
A Be sure to stop the engine and remove the key
before cleaning air cleaner element.
1. Remove the air cleaner cover and the element.
(1) Undo the hook.
(2) Turn the cover clockwise and detach it.
2. Clean the element:
(1) When dry dust adheres to the element, blow
compressed air from the inside, turning the
element. Pressure of compressed air must be
under 205kPa (2.1kgf/
(2) When carbon or oil adheres to the element, soak
the element in detergent for 15 minutes then wash
it several times in water, rinse with clean water
and dry it naturally. After element is fully dried,
inspect inside of the element with a light and
check if it is damaged or not. (referring to the
instructions on the label attached to the case.)
3. Replace air cleaner element:
Once yearly or after every sixth cleaning, whichever
comes first.
A Checked to see if the evacuator valve is blocked with
dust.
(1) Element
(2) Cover
(3) Evacuator valve
A The air cleaner uses a dry element, never apply oil.
A Do not run the engine with filter element removed.
A Align the arrow marks when reinstalling the cover. If
the cover is improperly fitted, dust passes by the baffle
and directly adheres to the element.
61
, 30psi).