2. Getting Started
This chapter describes how to set up the Parani-ESD for the first time.
- 2.1 Panel Layout explains the panel layout.
- 2.2 Connecting the Hardware describes how to connect the Parani-ESD, the power, and the serial
device to the Jig Board.
Following items are pre-required to get started.
- One Jig Board (included in the Starter Kit package).
- One DC power adapter or one USB power cable (included in the Starter Kit package).
- One serial console cable for configuration (included in the Starter Kit package).
- One PC with RS232 serial port.
- Terminal emulation program running on the PC
2.1. Panel Layout
This section describes the panel layout of the Development Board.
2.2. Connecting the Hardware
This section describes how to connect the Parani-ESD to the Development Board and the Development
Board to the serial device for initial testing.
- Connect the Parani-ESD to the Development Board.
- Connect a power source to the Development Board for the Parani-ESD.
- Connect the Development Board for the Parani-ESD to a serial device.
Figure 2-1 The Panel Layout of Development Board
9