Table of Contents
Advertisement
B.3.10. AT+MLIST?
CURRENT MODE:SINGLE CONNECTION MODE
Response
OK
Display the current multiple connection mode and connected slave's Bluetooth addresses.
Purpose
Description
Display current mode(SINGLE CONNECTION MODE , MULTI-DROP MODE, NODE
SWITCHING MODE) and connected slave Bluetooth address.
Example
AT+MLIST?
CURRENT MODE: MULTI-DROP MODE
TASK1 – 000195000001
TASK2 – DISCONNECT
TASK3 – DISCONNECT
TASK4 – 000195000004
B.3.11. AT+BTMODE,n
OK
Response
Purpose
Set operation mode
Parameters
n=0: MODE0 (Default)
n=1: MODE1
n=2: MODE2
n=3: MODE3
When the operation status is 'Pending' currently, change the status to 'Standby' with
Description
AT+BTCANCEL prior to this command.
To take effect the ATZ must be executed or Powercycle the unit
Example
AT+BTMODE,2
OK
ATZ
B.3.12. AT+MULTI,n
Response
(n = 0)
OK
(n = 1 or n = 2)
TASK1 OK
TASK2 OK
TASK3 OK
TASK4 OK
Purpose
Set multiple connection mode
Parameters
n=0: Single Connection Mode (Default)
n=1: Multi-Drop Mode
n=2: Node Switching Mode
Description
Set single connection mode, multi-drop mode or node switching mode.
B.3.13. +++
OK
Response
Convert the operation status of 'Connect' to 'Standby'
Purpose
In 'Connect' status, data from host is transmitted to the other side Bluetooth device, and
Description
any AT command is not accepted but this command, which is not echoed on the screen.
When Parani-ESD encounters a character '+' from host, it stops the data transmission and
44
Advertisement
Table of Contents
