OK
ERROR
Purpose
Connect to a specific Bluetooth device with a given BD address
Parameters
112233445566=BD address
Description
Parani-ESD attempts to connect to the Bluetooth device with the given BD address. To
make successful connection, the Bluetooth device must be in Page scan mode. This
attempt continues for 5 minutes.
If it fails to make connection, response is 'ERROR'.
Example
ATD000B530011FF
B.3.22. ATA
OK
Response
Start ACL Open
ACL Connect Success
Purpose
ACL connect to the last connected Bluetooth device
If it make connection, response will display an 'ACL Connect Success'. Must have reboot
Description
for new ACL connection.
B.3.23. ATA112233445566
OK
Response
Start ACL Open
ACL Connect Success
Purpose
ACL connect to a specific Bluetooth device with a given BD address
Parameters
112233445566 = BD address
Description
Parani-ESD attempts to ACL connect to the Bluetooth device with the given BD address. To
make successful ACL connection, the Bluetooth device must be in Page scan mode. If it
make connection, response will display an 'ACL Connect Success'. Must have reboot for
new ACL connection.
Example
ATA0001950011FF
B.3.24. ATH (ATHx, ATHbdaddr)
OK
Response
DISCONNECT
Purpose
Release the current connection
Description
The current Bluetooth connection will be disconnected. It takes about Supervision
Timeout(S37) to detect an abnormal disconnection such as power off and moving out of
service range. In multiple connection modes, a specific connection can be specified to be
disconnected by specifying the connection number or the Bluetooth address.
The response message of 'DISCONNECT' may be displayed on disconnection depending
on the disconnection condition. You can make it not displayed using S10 register.
Example
ATH
ATH3
ATH000195000001
47