B.3.30. AT+BTNAME=$string
OK
Response
Purpose
Change device name
Parameters
$string= New device name (Default="ESDV2_v2.0.0-445566")
Description
Parani-ESD can have a user friendly name for easy identification. The name allows up to
30 alpha-numeric characters.
Example
AT+BTNAME="My-Parani-ESD"
B.3.31. AT+BTLPM,n
OK
Response
Purpose
Set low power mode
Parameters
n=0: Inactivate (Default)
n=1: Activate
Description
During no data transmission, Parani-ESD can be in low power mode to save the power. It
takes a few seconds to wake the Parani-ESD out of low power mode.
B.3.32. AT+PASS=$string
Response
Remote Configuration Enabled
Purpose
Input password in remote configuration mode.
Parameters
$string= Password (Default="0000")
Description
Input password for authentication in remote configuration mode.
Example
AT+PASS=1234
B.3.33. AT+CHPASS=$string
OK
Response
Purpose
Change password used in remote configuration mode.
Parameters
$string= New password
Description
Change password used in remote configuration mode. Password length is up to 8.
Example
AT+CHPASS=12345678
B.3.34. AT&V
S0:m0;S1:m1; ...Sn:mn
Response
OK
Purpose
Display all the S-registers
Description
All parameters are stored at S-register in flash memory. These values are sustained until
hardware reset.
49