Troubleshooting/Repair - Nikon COOLSHOT 50 i Instruction Manual

Troubleshooting/Repair

En
If this product fails to function as expected, check the list below before consulting your local dealer or the
Fr
store where you purchased it.
l l If there is a problem with the product.
Problem
• Does not turn on
• Unable to measure
• Anomalous result
• Cannot see the internal display
• Difficult to see the internal display
l l If you require a repair, please contact your local dealer or the store where you purchased the product.
Do not repair or disassemble. It may result in a serious incident.
Please note that Nikon is not responsible for any direct or indirect damage if the user attempts to repair or
disassemble the product.
l l About performance parts for repair and the repairable period
The repairable period is within the holding period of performance parts for repair (parts necessary to
maintain performance). In some cases, repairs may be possible even after the parts holding period has
passed, so please contact a Nikon service organization, the store where you purchased the product, or
your nearest dealer. In addition, if the product is found to be completely damaged due to malfunction or
damage caused by submersion, fire, or dropping, it cannot be repaired even within the holding period.
Evaluation of the degree of failure or damage is at the discretion of the Nikon service organization.
22
• Press the PWR button (top of the body).
• Check that the battery is inserted correctly.
• Replace the battery with a new one.
• Confirm the settings.
• Confirm if it can measure a large target close to you (example: a building
approx. 15 m/yd. ahead of you).
• Clean the lens surface if necessary.
• Check the brightness of the internal display, and adjust it as necessary.
Cover the objective lens so that checking the internal display is easier.
Cause/Solution