Typical Installation; Mount The Pump And Connect Chemical Supply - Graco A22600 Instructions Manual

Installation

Typical Installation

F . 1:
IG
F . 1 is an example of an installation with a Python
IG
XL-DA25 chemical injection pump. Your installation may
differ from what is shown here. (See Required Acces-
sories, page 7.) The Python XL-DA25 pump (F) and
secondary bleed-type pneumatic valve (B) are the only
components in F . 1 supplied by Graco. All other com-
IG
ponents are supplied by customer.
Key:
A Main pneumatic supply line
B Secondary bleed-type pneumatic valve
C Pneumatic filter
D Primary bleed-type master pneumatic valve
E Pneumatic pressure regulator
F Pump
G Manifold assembly (includes Y-strainer and fluid shutoff
valve (H))
H Fluid shutoff valve (inlet & outlet)
J Fluid pressure relief valve
K Fuid inlet line
L Inlet port
M Outlet port
N Pneumatic lubricator
P Fluid outlet line
R Speed control valve
S Lift ring (for lifting the pump only)
T Check valve
8
H
P
T
H
G
K
Mount the Pump and Connect
Chemical Supply
The pump can be bolted to a wall or skid by the attached
bracket.
NOTE: The pump must always be mounted vertically.
If you have an application, or mounting configuration,
that requires installation in a manner different than
depicted in F
for assistance.
NOTE: A Y-strainer (G) or chemical filter is required
before the pump inlet. This will keep debris from the
tank from reaching the pump seals. Fluid filters are
available from Graco.
1. Mount the pump (F) and connect the fluid inlet
line (K).
A
E
B
F
C
J
M
. 1, please contact your Graco distributor
IG
N
D
S
R
L
3A6831G