Table of Contents
Advertisement
2. Installation
Switch off ignition and disconnect the vehicle's battery! The interface needs a permanent
12V source. If according to factory rules disconnecting the battery is to be avoided, it is
usually sufficient to put the vehicle is sleep-mode. In case the sleep-mode does not show
success, disconnect the battery with a resistor lead.
If power source is not taken directly from the battery, the connection has to be checked
for being start-up proven and permanent.
2.1.
Place of installation
The interface is installed on the backside of the head-unit.
Version 18.12.2014
VL2-MIB-2
Advertisement
Table of Contents
Need help?
Do you have a question about the VL2-MIB-3 and is the answer not in the manual?